|
|
|
|
Metal Slitter Line Variables Sources of Slit Width Variations & Burr
| Material Thickness |
Condition of Slitter Head |
| Clearance |
Arbor Lockup System |
| Thickness Variability |
Incoming Strip Shape |
| Strength of Material |
Quality/Skill of Operator |
| Ductility of Material |
Temperature of Tooling & Material |
| Strip/Mult Width |
Arbor Deflection |
| Knife Edge Condition |
System Lubricity |
| Knife ø |
Spacer Materials |
| Knife Thickness |
Tooling Tolerances |
| Spacer ø |
Poor RMS on Knife Faces |
| Stripper Ring Practice |
Pickup on Knife Faces |
| Uncoiler Tension |
Excessive Overlap |
| Recoiler Tension |
Pulling Trim on an Angle |
| Speed Synchronization |
Strands Dancing in Pit |
| Pass Line Configuration |
Separator Clearance Too Tight |
| Speed of Operation |
Pick up on Seperator Discs |
| Condition of Tooling |
Poor RMS on Separator Discs |
|
|
|
You are at: Home > Support > Technical Bulletins > Metal Slitter Line Variables Sources of Slit Width Variations & Burr
|
